Hi
Thanks for answer.
Yes, I got the manuals. But the FT2000 manual don't explain what is used for
other amps and difference between BAND DATA connector or the RCA connector
board at the rear of Yaesu FT-2000, I have never touched a Yaesu. Hi hi
Also got direct mail from W4TV Joe which confirmed what I had "mixed"
together of those manuals.
73s Rag LA6FJA
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Roger (sub1)
Sent: Wednesday, April 13, 2011 6:56 AM
To: amps@contesting.com
Subject: Re: [Amps] Wiring Expert 1K-FA Linear Amplifier & Yaesu
FT2000..help needed!
On 4/13/2011 12:19 AM, Stein Roar Brobakken wrote:
> Hi
>
>
>
> I am going to setup a new Expert PA and a Yaesu FT2000.
>
> In the SPE manual http://www.ea4tx.com/files/EXPERT1K-FA-EN.pdf
>
>
If you search the archives we went through this about two years ago when
I was hooking up a Tokyo Hy-Power HL-1.5Kfx to a Yaesu FT897D. The 897D
uses the mini DIN connector with a different pin out, so we had to
convert from the regular DIN to the Mini. There were several who posted
the pinouts for the 2000 IIRC.
73
Roger (K8RI)
> we want to use the BAND Data Interface from Yaesu FT2000> PA
Somewhere in that Yaesu manual should be a listing of the connectors and
which one is used for the "band data" out.
The manuals are also available in downloadable PDFs on the Yaesu site,
which are searchable. That might help.
73 and good luck,
Roger (K8RI)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|