Amps
[Top] [All Lists]

Re: [Amps] FW: [Boatanchors] Best Boatanchor 160-10mReceiversforSSB?

To: Carl <km1h@jeremy.mv.com>, Rob Atkinson <ranchorobbo@gmail.com>
Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor 160-10mReceiversforSSB?
From: "Fuqua, Bill L" <wlfuqu00@uky.edu>
Date: Sun, 5 Jun 2011 17:48:47 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
You know, I have never tried the CE slicer.
How has had some experience with it?
 I assume it is phaseing.
wa4lav

________________________________________
From: Carl [km1h@jeremy.mv.com]
Sent: Sunday, June 05, 2011 5:30 PM
To: Rob Atkinson; Fuqua, Bill L
Cc: amps@contesting.com
Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor 160-10mReceiversforSSB?

I paid $100-150 for the 3 of mine but Ive seen them over $400 on Fleabay.
The CE B Slicer and one from RME are others I use that cost a lot less.

Carl
KM1H


----- Original Message -----
From: "Rob Atkinson" <ranchorobbo@gmail.com>
To: "Fuqua, Bill L" <wlfuqu00@uky.edu>
Cc: <amps@contesting.com>
Sent: Sunday, June 05, 2011 4:15 PM
Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor
160-10mReceiversforSSB?


Because I did not know they were going for that much.  Where do you
see the high prices?  under tables at flea markets?

Rob
K5UJ

On Sun, Jun 5, 2011 at 1:21 PM, Fuqua, Bill L <wlfuqu00@uky.edu> wrote:
> With HC10 going for more than receivers such as HQ180s and HQ170s why
> would you buy one?
> These have the same IF ans in the HC10.
> 73
> Bill wa4lav
>
> ________________________________________
> From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf
> Of Rob Atkinson [ranchorobbo@gmail.com]
> Sent: Sunday, June 05, 2011 1:40 PM
> To: amps@contesting.com
> Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor
> 160-10mReceiversforSSB?
>
> If you wind up with an old AM/CW rx with a 455 KHz IF you can keep a
> look out for a hammarlund HC-10 and it will give you SSB coverage and
> maintain the tube signal chain.
>
> I don't know what the prices are but RME might be a manufacturer to
> look for. I have seen NC300s go for pretty cheap so that is certainly
> a very good rx for the money and ya gotta love that weighted flywheel
> tuning.
>
> 73
>
> Rob
> K5UJ
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1382 / Virus Database: 1511/3682 - Release Date: 06/05/11


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>