OM's,
FWIW, the Collins 75A-4 covers 160 mtrs, what else would you ever need for
160 ?
73,
Dave
----- Original Message -----
From: "Fuqua, Bill L" <wlfuqu00@uky.edu>
To: "Carl" <km1h@jeremy.mv.com>; "Rob Atkinson" <ranchorobbo@gmail.com>
Cc: <amps@contesting.com>
Sent: Sunday, June 05, 2011 4:48 PM
Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor
160-10mReceiversforSSB?
> You know, I have never tried the CE slicer.
> How has had some experience with it?
> I assume it is phaseing.
> wa4lav
>
> ________________________________________
> From: Carl [km1h@jeremy.mv.com]
> Sent: Sunday, June 05, 2011 5:30 PM
> To: Rob Atkinson; Fuqua, Bill L
> Cc: amps@contesting.com
> Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor
> 160-10mReceiversforSSB?
>
> I paid $100-150 for the 3 of mine but Ive seen them over $400 on Fleabay.
> The CE B Slicer and one from RME are others I use that cost a lot less.
>
> Carl
> KM1H
>
>
> ----- Original Message -----
> From: "Rob Atkinson" <ranchorobbo@gmail.com>
> To: "Fuqua, Bill L" <wlfuqu00@uky.edu>
> Cc: <amps@contesting.com>
> Sent: Sunday, June 05, 2011 4:15 PM
> Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor
> 160-10mReceiversforSSB?
>
>
> Because I did not know they were going for that much. Where do you
> see the high prices? under tables at flea markets?
>
> Rob
> K5UJ
>
> On Sun, Jun 5, 2011 at 1:21 PM, Fuqua, Bill L <wlfuqu00@uky.edu> wrote:
>> With HC10 going for more than receivers such as HQ180s and HQ170s why
>> would you buy one?
>> These have the same IF ans in the HC10.
>> 73
>> Bill wa4lav
>>
>> ________________________________________
>> From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf
>> Of Rob Atkinson [ranchorobbo@gmail.com]
>> Sent: Sunday, June 05, 2011 1:40 PM
>> To: amps@contesting.com
>> Subject: Re: [Amps] FW: [Boatanchors] Best Boatanchor
>> 160-10mReceiversforSSB?
>>
>> If you wind up with an old AM/CW rx with a 455 KHz IF you can keep a
>> look out for a hammarlund HC-10 and it will give you SSB coverage and
>> maintain the tube signal chain.
>>
>> I don't know what the prices are but RME might be a manufacturer to
>> look for. I have seen NC300s go for pretty cheap so that is certainly
>> a very good rx for the money and ya gotta love that weighted flywheel
>> tuning.
>>
>> 73
>>
>> Rob
>> K5UJ
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1382 / Virus Database: 1511/3682 - Release Date: 06/05/11
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|