Thanks Carl. Good advice.
And yes, I do have the glitch...
73's
Ulf (SM0NOR)
ulf@sm0nor.com
On 6 dec 2011, at 22:30, Carl wrote:
> The US built 811's usually dont need any special handling but Id still be
> sure to have a glitch resistor in the HV, the cover off and one hand on the
> power switch as no tube is impervious to gas arcs. However 1988 isnt that old
> and Cetron built excellent tubes.
>
> Carl
> KM1H
>
> ----- Original Message ----- From: "Ulf (SM0NOR)" <ulf@sm0nor.com>
> To: "Amps reflector" <amps@contesting.com>
> Sent: Monday, December 05, 2011 5:36 PM
> Subject: Re: [Amps] Cetron 811a.
>
>
>> No takers?
>> This ought to be a very simple question :)
>>
>>
>> 73's
>>
>> Ulf (SM0NOR)
>> ulf@sm0nor.com
>>
>>
>>
>> On 4 dec 2011, at 11:23, Ulf (SM0NOR) wrote:
>>
>>> Hi all,
>>>
>>> I recently bought 4 Cetron 811a from Nebraska Surplus, date coded 1988.
>>> I intend to put them into a home brewed amp that is real close to smoke
>>> testing.
>>> Is there any start up procedure that is recommended for NOS 811:a? I have
>>> not come across any recommendation regarding this so far. But before, I put
>>> them in and apply filament and HV, I thought i'd ask here.
>>>
>>> Thanks!
>>>
>>>
>>> 73's
>>>
>>> Ulf (SM0NOR)
>>> ulf@sm0nor.com
>>>
>>>
>>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>> -----
>> No virus found in this message.
>> Checked by AVG - www.avg.com
>> Version: 10.0.1415 / Virus Database: 2102/4060 - Release Date: 12/06/11
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|