Use 6A10's with suffiicient lead length for heat sinking and cast your own
blocks.
Carl
KM1H
----- Original Message -----
From: "Jim Garland" <4cx250b@muohio.edu>
To: <amps@contesting.com>
Sent: Tuesday, December 06, 2011 3:20 PM
Subject: [Amps] rectifier diode modules
> I'm looking for suggestions for a source of diode blocks to use in a
> couple
> of HV power supplies. I'm using a bridge rectifier and would like to have
> 8KV-10KV PRV per block. The power supply will be rated at 2A DC, so I'd
> like
> at least 1A max continuous rating per block.
>
>
>
> I have some blocks scavenged from an old ARD-230C amplifier rated at
> 8IV/750mA. I ran one for 45min at an amp with no problems, so I can
> probably
> make do with those if I can't find any others. They're made by a company I
> never heard of, but are very attractive.
>
>
>
> Henry Radio sells "half-bridges" which are rated at 15KV/1.5A, but that is
> 7.5KV per leg and I'd like a bit more.
>
>
>
> This is all about cosmetics, by the way. I know I can string a bunch of
> e.g., 1N5408 diodes, but I prefer the elegance of blocks.
>
> Tnx,
>
> Jim W8ZR
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1415 / Virus Database: 2102/4060 - Release Date: 12/06/11
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|