Amps
[Top] [All Lists]

Re: [Amps] Grid current protection HELP

To: amps@contesting.com
Subject: Re: [Amps] Grid current protection HELP
From: Michael Tope <W4EF@dellroy.com>
Date: Mon, 13 Feb 2012 18:14:53 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I don't see how the opto-isolator triggers anything. According to the 
schematic it switches 100K to ground on a node fed by the output of a 
7815 regulator. That doesn't make any sense to me. I think there are 
some errors in the schematic. There is probably a pull-up between pin 2 
of the 555 and the 7815 output instead of just a wire, I think that 
creates other problems, so without staring at it for more time than I 
have tonight, I can't tell you exactly how it is supposed to be 
configured. I just can't see how it could possibly work the way the 
schematic shows it.

73, Mike W4EF..............

On 2/13/2012 4:59 PM, rick darwicki wrote:
> Hi all,
>
> A while back K6XX published an article that can be found at  
> members.cruzio.com/~k6xx/radio/76a_prot.pdf
> It is a simple opticoupler that triggers a 555 timer base on the voltage drop 
> across a resistor.
> I built the circuit but only connected pin 2 to the 100k resistor from the 
> opticoupler.
> It has different levels of working with different connections I have tried. 
> Grounding the relay jack will key Q1 if the output is low, but it starts 
> high. At one point I could vary the voltage in to the opticoupler and trigger 
> the 555. Also, the time delay worked too. Now I can't get it to do much hi hi 
> I need to start over.
>
> I'm a tube and voltage guy and almost nothing I've built SS except for a 160 
> meter surface mount SDR and my copy of the Alpha 78 QSK board has worked 
> first time out hi hi
>
> Can someone look at the schematic and let me know what the problem is, IE 
> correct it?
> I can see the trigger tied to B+ and do not think that is correct. 
> I assumed pin 4 needed to go to B+, maybe not.
>
> I made a PCB and it is a pain makeing changes and cutting foil.
>
> Please, any help from you solid state guys? My 8874s need you. K6XX does not 
> respond.
>
> Thanks
>
> Rick, N6PE
>
> ==================================
>
> Talk is cheap... except when Congress does it.
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>