It is a simple amp, doubt that both filaments would go out at the same
time..the transformer has all the windings on it, HV, filament, bias, so hope
its not your transformer.. had 2 of these in the past, still have one, my
primary amp, wonderful amp, built tough, similar to Collins since the designer
was an engineer at Collins before he started Hunter Electronics..
73, Tim K8WBL
--- On Fri, 6/8/12, Carl <km1h@jeremy.mv.com> wrote:
From: Carl <km1h@jeremy.mv.com>
Subject: Re: [Amps] Hunter 2000c
To: "Charles Hedrick" <cchedrick@gmail.com>, amps@contesting.com
Date: Friday, June 8, 2012, 7:39 PM
Start with the manual and follow the circuit, its a good but very basic amp.
Carl
KM1H
----- Original Message -----
From: "Charles Hedrick" <cchedrick@gmail.com>
To: <amps@contesting.com>
Sent: Friday, June 08, 2012 6:03 PM
Subject: [Amps] Hunter 2000c
> Hi all,
> We'll it was fine the day before yesterday, but last night I turned it on
> relays closed on xmit and no output. I looked and found the filaments
> were
> not glowing so suspect that circuit has an issue. I haven't put the
> beast
> on the bench yet, but has anyone experienced such an occurrence that can
> advise a starting place rather than a full circuit chase?
> Thanks
> WA4JKW
> Cam
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2433/5056 - Release Date: 06/08/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|