Or cut the filament pin(s) off as well as the grid pin and leave the dud
tube in there. Frn
----- Original Message -----
From: "Carl" <km1h@jeremy.mv.com>
To: "Patrick Barthelow" <apolloeme@live.com>; <amps@contesting.com>
Sent: Tuesday, June 12, 2012 8:49 AM
Subject: Re: [Amps] Alpha 76A 3 holer.... happy with just 2 tubes?
> Since the 2 holer uses the exact same tank circuit it will run just fine
> with reduced drive and a 1200W maximum output.
> Stuff something in the empty chimney to block air flow. An old sock works
> fine if its clean (-;
>
> Carl
> KM1H
>
>
> ----- Original Message -----
> From: "Patrick Barthelow" <apolloeme@live.com>
> To: <amps@contesting.com>
> Sent: Tuesday, June 12, 2012 10:03 AM
> Subject: [Amps] Alpha 76A 3 holer.... happy with just 2 tubes?
>
>
>>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|