I just installed on of these into my AL82:
http://home.earthlink.net/~wd7s/hv-2.htm
I had to drill some new holes, and make a mod or two to the new board, but
works great! I also installed one of my Step Start boards into it as well.
The Ameritron AL-82/1200/1500 is not quite up
to par. And the Ameritron SS doesn't step start the filament. Mine does.
73
Jim W7RY
-----Original Message-----
From: Alek Petkovic
Sent: Thursday, October 18, 2012 1:09 AM
Cc: amps@contesting.com
Subject: Re: [Amps] AL-1500 filter caps
That's not all.
The 8 capacitors are running right on the edge as well. They are 450V
rated and the plate voltage is 3600V. On days when the incoming mains is
a little higher, it is not uncommon for the plate voltage to be up
around 3750V.
I have bought 500V caps for my AL-1500 but I'm waiting for the summer
holidays to get the time to dive in and swaqp them out. Armed with the
resistor knowledge, I shall seek out suitable higher rated replacements
as well.
73, Alek.
VK6APK
On 18/10/2012 3:20 PM, Steve Thompson wrote:
Have they changed the resistors to ones properly rated for the job?
It's certainly an efficient spares service, but a shame they designed
something with a fundamental flaw built in.
Steve
A friend's AL-1500 started blowing fuses after the two minute timeout.
I isolated the problem to the filter cap board. After pulling the board,
I found that two or three caps had vented their guts onto the board.
I called Ameritron, and had the following conversation:
me - I need a set of 8 filter caps for an AL-1500
him - I assume you want the equalizing resistors too?
me - Hmm, I didn't even look at those.
him - the resistors usually go first, taking out the caps
me - ok, send the resistors too.
him - do you want just the parts, or the whole board?
me - Hmmm, how much is the whole board?
him - $20 more than just the parts
me - ok send the whole board
him - Ok that will be $167 including shipping.
I think that's pretty good service. I went back and checked the
equalizing resistors, and several were open, or way off value. It was a
good catch for him to mention the resistors. I might have missed that.
Those guys do know their product. It was nice to get a fully populated
board for only $20 more than just the parts.
Dave Hachadorian, K6LL
Yuma, Arizona
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
http://www.qrz.com/db/vk6apk
http://www.qrz.com/db/vk6ap
Family Businesses:
Petkovic Air& Gas. petkovicag@bigpond.com
SP Electrical. www.spelectrical.net.au
Hampers by Hand. www.facebook.com/hampersbyhand
=======
Email scanned by PC Tools - No viruses or spyware found.
(Email Guard: 9.0.0.2308, Virus/Spyware Database: 6.20820)
http://www.pctools.com/
=======
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|