Amps
[Top] [All Lists]

Re: [Amps] SHV connectors...

To: Jim Garland <4cx250b@miamioh.edu>
Subject: Re: [Amps] SHV connectors...
From: PY1NB - Felipe Ceglia <felipeceglia2@gmail.com>
Date: Fri, 15 Feb 2013 08:31:52 -0200
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Hi Jim,

Thanks for reply. I will give a try for the chinese connectors. I am afraid
of RG58, as by it specs its limit is 1900VRMS.

73,

Felipe Ceglia - PY1NB
-------------------------------------------------------------------------------------
PR1T team member /// Rio DX Group member /// Araucaria DX Group member
http://dxwatch.com /// http://reversebeacon.net /// http://riodxgroup.com


On Wed, Feb 13, 2013 at 5:17 PM, Jim Garland <4cx250b@miamioh.edu> wrote:

> Felipe,
> I think those connectors (reverse-polarity SHV-BNC) are intended for RG6,
> which I believe may be a larger diameter than RG142 (but more flexible).  I
> think RG6 Quad Shield is very high quality (and inexpensive) coax and
> should
> work fine. I've bought several of the Chinese connectors and compared them
> with Kings Electronics connectors, which are ten times the price, and find
> the quality to be quite comparable. In general, I think the mechanical
> quality of the connector is more important than the dielectric strength of
> the cable for voltages less than  5 KV. For instance, I've been using MHV
> connectors (now obsolete, with a lower voltage rating) with ordinary RG58
> cable for twenty-five years with my 8877 amp and it has handled 4700V
> perfectly well.
> 73,
> Jim W8ZR
>
> > -----Original Message-----
> > From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of PY1NB -
> Felipe Ceglia
> > Sent: Tuesday, February 12, 2013 8:46 AM
> > To: amps@contesting.com
> > Subject: [Amps] SHV connectors...
> >
> > Hi folks,
> >
> > I cannot find any reasonable priced source for RG8 sized SHV connectors.
> >
> > The fair priced are these ones, from a chinese online store:
> > http://www.rfsupplier.com/straight-plug-crimp-5000v-cable-p-1684.html
> >
>
> http://www.rfsupplier.com/high-voltage-solder-bulkhead-jack-connector-p-1685
> .html
> >
> > For a 4.5kv@1a  dc power supply, should I use this connector and RG142
> > cable?
> >
> > 73,
> >
> >
> > Felipe Ceglia - PY1NB
> >
>
> ----------------------------------------------------------------------------
> ---------
> > PR1T team member /// Rio DX Group member /// Araucaria DX Group member
> > http://dxwatch.com /// http://reversebeacon.net ///
> http://riodxgroup.com
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>