>
> Yes those GE CL-60 NTC inrush limiting thermistors are helpful albeit still
> yield a fairly fast rise time constant in the filament voltage. The far
> gentler slow 3 to 4 second ramp up from the Triac controller is more
> elegant. The slow soft-start circuit is based on the ON Semiconductor
> TDA1085C IC chip and a 40A Triac.
>
> In fact I've also got a couple of CL-60 thermistors (one in each leg) the
> primary of the Kenwood TL922 amp's filament transformer to trim / fine-tune
> the steady-state filament voltage measured right at the tube socket to circa
> 4.9 Volts, as the factory stock filament voltage is on the high side; around
> 5.2 to 5.3 Volts. That slight over voltage can also shorten the 3-500Z tube
> emission life.
>
> Leigh
25/06/2013 10:24
Do you a schematic you would share for the Triac soft start setup
please Leigh?
Thanks.
--
Best Regards,
Chris Wilson.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|