> Did you take that measurement loaded @ 3A or no load?
> Randy AB9GO
> Please note: Upcoming Vacation: December 21 - January 5, 2014
> Randy E. Randall AB9GO
> Network Architect
> UC Health
> Randy.Randall@UCHealth.com
> Phone 513-585-7146
> Fax 513-585-7159
> -----Original Message-----
> From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Chris Wilson
> Sent: Wednesday, October 02, 2013 10:11 AM
> To: amps@contesting.com
> Subject: [Amps] Has this SMPS got too much ripple for a SS bias supply?
> 02/10/2013 15:09
> I have a Skanti commercial solid state 250W RF amp, 1 to 30 MHz. It
> needs 50 volts and 5 volts supplied to it. The 5 volts is for the
> bias circuits. I am told they draw about 3 amps maximum. I have a
> good quality regulated 4 amp SMPS at 5 volts. Here is a `scope
> screen shot of the ripple, measured without ground lead tails on the
> probe, direct across the output to minimize pick up. The dots are
> the cursors, it's an elderly Tek 7854 analogue `scope. Is this OK to
> use? Or do I build a linear regulated supply? Thanks.
> The `scope screen shot is at http://www.gatesgarth.com/ripple2.jpg
> as I don't know how to upload a shot here.
> --
> Best Regards,
> Chris Wilson.
> mailto: chris@chriswilson.tv
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> ________________________________
> Confidentiality Notice: This e-mail message, including any
> attachments, is for the sole use of the intended recipient(s) and
> may contain confidential and privileged information. Any
> unauthorized review, use, disclosure or distribution is prohibited.
> If you are not the intended recipient, please contact the sender by
> reply e-mail and destroy all copies of the original message.
02/10/2013 22:28
It was un loaded. Just the `scope connected.
--
Best Regards,
Chris Wilson.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|
