I'd like to point out that you should not use "FAST" diodes.
Use power diodes. If you use fast diodes you risk rectifying RF signal and
getting odd readings on your meters. I have actually seen this in a friend's
homebrew
amplifier. Power diodes have slower reverse recovery time and will not rectify
the RF
voltages induced by the strong fields inside the amplifier. Also, they are self
sacrificial
devices like fuses except internally they fuse to a short when if a large
impulse of current
passes thru them and voltage drop goes to zero.
One other thing. If you try to arrange it so that the voltage across the
diode is around
.7 volts just beyond the meter peg, the meter will not be accurate. Don't
forget that
the diode draws current at lower voltages. The .7 volts is just an
approximation used
mostly for power supply design and testing purposes.
73
Bill wa4lav
________________________________________
From: Amps [amps-bounces@contesting.com] on behalf of Bill Turner
[dezrat1242@yahoo.com]
Sent: Thursday, October 10, 2013 5:13 PM
To: Amps
Subject: Re: [Amps] high voltage fuses
ORIGINAL MESSAGE: (may be snipped)
On Thu, 10 Oct 2013 09:13:53 -0700, you wrote:
>We used to call this the 'voltmeter method' of measuring current. You put a
>resistor in
>series with a milliammeter to convert it into a voltmeter -- and then use it
>to measure
>the voltage drop across another resistor (the shunt) in series with the load.
REPLY:
No, that's not the same method. Yours works fine too, but it's different.
My method uses a current meter, not a voltmeter. The meter would be the same
range you would use without any protection, i.e. 1 amp for plate, 100 mA for
grid, etc. NOT a voltmeter.
The current meter and a low value resistor are in series. The purpose of the
resistor is to increase the total voltage drop across the meter plus
resistor to about .6 VDC, at which point the protective diode will conduct.
The value of resistor plus meter resistance should be so that the .6 VDC
figure is reached at about 110% of full scale.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|