ORIGINAL MESSAGE: (may be snipped)
On Wed, 6 Nov 2013 10:11:12 -0000, Ian wrote:
>The best solution is to mechanically adjust the meter needle
>further up-scale toward the center. As well as the front-panel
>screwdriver adjustment, many meter movements have a coarse adjustment on
>the rear pivot.
REPLY:
The "best" solution?
How is that better than simply using a zero-center meter in the first place?
Your method gives a reading that is constantly in error by the amount of
off-zero adjustment.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|