Amps
[Top] [All Lists]

[Amps] Command Technologies HF2500

To: "amps@contesting.com" <amps@contesting.com>
Subject: [Amps] Command Technologies HF2500
From: "Brian Sarkisian, KG8CO" <cqkg8co@yahoo.com>
Reply-to: "Brian Sarkisian, KG8CO" <cqkg8co@yahoo.com>
Date: Sun, 24 Nov 2013 15:37:35 -0800 (PST)
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I recently picked up an Command Technologies HF-2500.  It is model number 222
so it been around for a while.

I have a few questions concerning the amp.

1.  I have seen a couple HF-2500 users guides.  One guide said the plate voltage
should idle around 2,400 volts and the other said 2,600 volt.  The meter on the
amp says it is sitting around 2,300 volts.  

Is that OK ?


2. I also notice while tuning the amp, the case resonates the hum of the power 
transformer.  We would there
be any issue placing 4 insulating bushings between the power transformer and 
the case ?

3. I have read the amp will also operate in 17 and 12 meters.   I haven't tried 
12 meters yet, but am
only able to get about 500 watts out on 17.  Any ideas, and would any one have 
initial tuning settings
for 12 and 17 meters.

Thank you


Brian, KG8CO
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>
  • [Amps] Command Technologies HF2500, Brian Sarkisian, KG8CO <=