Amps
[Top] [All Lists]

Re: [Amps] Fan Noise in GS-35b Amplifiers

To: "John G3UUT" <amps@grebe.plus.com>, <amps@contesting.com>
Subject: Re: [Amps] Fan Noise in GS-35b Amplifiers
From: "Carl" <km1h@jeremy.mv.com>
Date: Fri, 21 Feb 2014 19:17:11 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Ive already mentioned the EBM Papst 4600N as an adequate substitute earlier in this thread. Ive used them and altho havent measured backpressure the spec sheet curve inticates it handles backpressure quite well unlike most muffin type fans. It does a more than adequate job on three 3CX800A7's as factory installed in the LK-800 series.

Carl
KM1H


----- Original Message ----- From: "John G3UUT" <amps@grebe.plus.com>
To: <amps@contesting.com>
Sent: Friday, February 21, 2014 6:03 PM
Subject: Re: [Amps] Fan Noise in GS-35b Amplifiers


A possible blower you could consider is the EBM Papst G1G108-AB17-02, this is capable of over 100 CFM at low pressures and could well be adequate if you are not going to push things too hard. The good thing about it is that the speed can be controlled by an external DC voltage or resistor network which means it's possible to easily implement schemes to reduce the speed / noise when the temp of the outlet air is low.

I've never actually used one of these these blowers but had it in mind for an amp I've been planning so don't blame me if it's really noisy. However I don't think it's likely to be too bad because; a) its a diecast spiral and in my experience these are quieter than sheet metal and b) My experience with Papst blowers and fans has been very positive. Anybody else tried them?

If all else fails just cook the thing like the rest of us do, the GS35b is just about the most rugged valve there is and they are not too expensive either and if you really fry it you can get your money back on the cooler at the scrap metal dealer.

Have fun
John G3UUT

On 19/02/2014 16:07, Jack C. Shutt wrote:
I have gathered from all the info that I have read on amps using the GS-35b that a healthy air flow is necessary to keep these tubes happy. Unfortunately, the 100 CFM squirrel cage blower that is recommended for this purpose is quite noisy. Any suggestions for an effective cooling arrangement that is quieter? I thought about remotely locating the blower and using a hose duct to the amp, but this is just not practical in my shack. Suggestions? 73, Jack, W9GT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4335 / Virus Database: 3705/7115 - Release Date: 02/21/14


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>