Here is chapter and verse on the 3-500 problem by the late Bill Orr W6SA.
73, John G3JVC/GM3JVC.
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Alf Pousar
Sent: 14 May 2014 09:15
To: Amps@contesting.com
Subject: [Amps] 3-500Z pin becomes unsoldered
If your solder lugs are dripping the solder due to heath, clean the lug
using a good desolder wick and wrap the wire around and trough the lug. Then
take some small wrapp wire and wrapp around the lug.
Then... solder with high temp ten/silver solder and the problem is gone.
Alf OH2QM
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4577 / Virus Database: 3950/7488 - Release Date: 05/13/14
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|