Just use torch and melt the solder holding it all together.
The ceramic pieces are silver soldered to each other and
to metal components. It may help to first drill a small hole
to remove vacuum so it will easily fall apart when you melt the
solder.
________________________________________
From: Amps [amps-bounces@contesting.com] on behalf of Mike McCarthy, W1NR
[lists@w1nr.net]
Sent: Friday, March 06, 2015 12:33 PM
To: amps@contesting.com
Subject: Re: [Amps] low output with QRO amp - SUCCESS-
Are you sure the tube does not use beryllium?
Mike, W1NR
On 03/06/2015 11:34 AM, Steve Bookout wrote:
>
> I think I will take my Dremel tool, with the rotary diamond disk, to the
> dud just to see what it looks like inside.
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|