Also see:
http://somis.org/
There's a wealth of good stuff on the TL-922 there.
http://www.pa0fri.com/
Click on Mods and then Kenwood TL-911 modifications. It actually
describes the TL-922.
73, Alek
VK6APK
*
*
On 29/10/2015 5:30 AM, Vic Rosenthal 4X6GP/K2VCO wrote:
W8ZR designed a sequencer board sold by Harbach which will protect
your relays, amplifier and transceiver. See
<http://w8zr.net/QSK/index.htm>. This is the best way. Whatever you
do, you should read his QST article that is linked there.
If you know that your transceivers provide enough time after asserting
key out and before producing RF, as well as a reasonable delay after
RF stops and before key out goes back to the receive state, then you
can just use a pair of vacuum relays or a vacuum relay and a reed
relay to replace the open frame relay in the TL922. Exactly how you do
this will depend on the coil voltage requirements of the relays that
you use.
73,
Vic, 4X6GP/K2VCO
Rehovot, Israel
http://www.qsl.net/k2vco/
On 28 Oct 2015 23:04, Arnie Pfingst wrote:
I have a tl 922a with 10m amp driven by a Kenwood ts 940 or Yaesu ft
950 . It all works great except for the slow change over relay in the
amp. Im using the arb 704 interface for keying. I need a good mod for
the slow relay! After all this time I'm going to order the Harbach
soft start, and filter kit and will adjust the FIL voltage as needed.
Does anybody have any other ideas?ThanksArnie. Kd6cz
Sent via the Samsung Galaxy S®6 active, an AT&T 4G LTE smartphone
_______________________________________________ Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
http://www.qrz.com/db/vk6apk
http://www.qrz.com/db/vk6ap
Family Businesses:
SP Electrical. www.spelectrical.net.au
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|