Amps
[Top] [All Lists]

Re: [Amps] Answer about heat failure

To: hs0zcw@gmail.com, amps@contesting.com
Subject: Re: [Amps] Answer about heat failure
From: Riichard Neuman via Amps <amps@contesting.com>
Reply-to: Riichard Neuman <secopsys@aol.com>
Date: Sun, 16 Oct 2016 21:37:40 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
 While in fact true,  recent case studys have found that EHFAS (Excessive Heat 
Failure Anxiety Syndrome) have been found treatable in more than 50% of 
reported cases by installing a higher GPM water circulation pump in the 
patient's "less-headroom" amplifier.

Richard  K3IPK

 

 

-----Original Message-----
From: Charles Harpole <hs0zcw@gmail.com>
To: amps <amps@contesting.com>
Sent: Sun, Oct 16, 2016 12:21 pm
Subject: [Amps] Answer about heat failure

The answer is TRUE.All failures of ham radios are caused, ultimately, by 
heat.Other suggestions......-vibration, which causes some component to break 
which cause othercomponents in the circuit to over-heat and fail.-component 
defect, or component just not installed causes surroundingcomponents to 
over-heat and fail.-operator mistakes which over-heat mis-adjusted circuits.and 
finally,-UPS-caused failures remain a mystery but customer anger is large 
source ofheat.Thanks to all who answered or just laughed.  But, don't make me 
ask "whatmakes a tube soft?"​73, signed in spirit of fun,​Charly, 
HS0ZCW_______________________________________________Amps mailing 
listAmps@contesting.comhttp://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>