Amps
[Top] [All Lists]

[Amps] PowerGenius XL Video

To: <amps@contesting.com>
Subject: [Amps] PowerGenius XL Video
From: "Jim Thomson" <jim.thom@telus.net>
Date: Fri, 10 Feb 2017 10:30:17 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Date: Fri, 10 Feb 2017 08:18:16 -0700
From: Richard Solomon <dickw1ksz@gmail.com>
To: Amplifiers <amps@contesting.com>
Subject: Re: [Amps] PowerGenius XL Video

Interesting that the ad says 100% Duty
Cycle then later says ..."ICAS"... ??

Maybe the terminology has changed
over the years.

73, Dick, W1KSZ

##  I saw the same video... listen carefully, and you can hear fans screaming 
in the
background, with 1.5 kw po on CW mode.   I e-mailed em and asked what do they
mean by 100%  duty cycle icas.   Will it operate at 1.5 kw FM  or  1.5 kw  
RTTY..or not. 
Also, what is the eff, esp when run at reduced po.   And what is the IMD, esp 
7-9-11-13 etc. 

##   Answer back was they will be running some tests on all of the above.  I 
shoulda also asked
how many dba are the fans,  from say 3 ft away.  The apache labs anan 8000  
xcvr, with its pre-distortion tricks, will
improve the typ linears  imd by 10 db.  Problem is, the dreaded  20-30 msec 
delay..which flat out wont work
if trying to monitor your self with headphones on. 

##  If it ends up being $7-10K..and  cant be used for FM or  RTTY at full 
power, I would pass on it myself. 
The dishtronix SS amp has lousy imd with its  -30db pep for IMD3, so its off my 
list.   Im not prepared to spend huge
$$ on an Icas rated amp...that’s only good for cw and ssb at full po..and 
reduced po on fm and rtty.  

##  the diplexer used on the new flex radio.. pwr genius is a winner.   The 
output is fed to the input of a LP and also
a  HP filter.  Output of HP filter  is fed to a 50 ohm dummy load.   3rd 
harmonic of these SS  amps is typ only 11 db down,
and thats like 120 w  reflected from a 1500w fundamental.   Thats a bunch.  The 
120 w is not absorbed by the LP filter, nor is
it routed to ground, its instead reflected back into the output of the amp.   
Increasing heat, reducing eff, and makes for lousy IMD. 
Any HP filter only has to be able to handle the PO of the harmonics so its 
requirements are not as great as the mating LP filter. 
The 50 ohm load for the HP filters can also be external. 

##  No mention of the hardware IMD correction scheme used in the pwr genius.  
At least they are on the right track. Hats
off to em. 

Jim  VE7RF 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>