Please read the question!!!!! I'm looking for info on the PAD not the
regulations
that require the pad!
73, Roger
On 5/5/2017 5:52 PM, Glen Zook wrote:
The rule is only for commercially manufactured amplifiers that are offered for
sale in the United States and possessions. Home brew amplifiers, modified
amplifiers, etc., are exempt from the regulation. You do need to make sure
that the amplifier meets the standards in 47 CFR Part 97 Section 97.307.
However, all equipment needs to meet 97.307 no matter what the origin.
Glen, K9STH
Website: http://k9sth.net
--------------------------------------------------------------------------------
*From:* John Simmons <jasimmons@pinewooddata.com>
*To:* Roger D Johnson <n1rj@roadrunner.com>
*Cc:* Amplifier Reflector <amps@contesting.com>
*Sent:* Friday, May 5, 2017 11:44 AM
*Subject:* Re: [Amps] 1.3K-FA
See: http://w6pql.com/parts_i_can_provide.htm
<http://w6pql.com/parts_i_can_provide.htm>about 2/3 down the page,
"**HF, VHF and UHF input attenuators for LDMOS amplifiers", **Then
"Click here for additional info" Jim's boards are very nicely made and
inexpensive**. **Pick out what you want and order from him. He usually
ships from stock and is great to deal with.
Subtract 15dB from the gain of your amp, then buy the attenuator to
match. However I don't think the rule applies to homebrew amps.**
**
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|