Amps
[Top] [All Lists]

Re: [Amps] Why a voltage doubler ?

To: "Richard Solomon" <dickw1ksz@gmail.com>, "amps" <amps@contesting.com>
Subject: Re: [Amps] Why a voltage doubler ?
From: "Carl" <km1h@jeremy.qozzy.com>
Date: Sat, 13 May 2017 18:55:57 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
The doubler had been used by hams since the 30's but made it into prime time with QST articles aimed at the Novice and other money challenged hams.

National and Collins were early users and within a few years almost everyone was doing it.

Ameritron still lives in the last century.

Carl


----- Original Message ----- From: "Richard Solomon" <dickw1ksz@gmail.com>
To: "amps" <amps@contesting.com>
Sent: Saturday, May 13, 2017 5:09 PM
Subject: Re: [Amps] Why a voltage doubler ?


Actually, the Yankee Skinflint in me likes
to think it had more to do with economics.

Copper wire and winding time is expensive.

73, Dick, W1KSZ

On Sat, May 13, 2017 at 2:00 PM, Ron Youvan <ka4inm@gmail.com> wrote:

    Paul Baldock wrote:

Why did early amplifiers use voltage doublers rather than twice the
secondary turns and a full wave bridge?


  I think it is for two reasons, to control the impedance of the power
supply and to limit the fault current, if there is an arc.  (anywhere)
Then on rebuilds cheapskate HAMs double the value of the capacitors and
increase the fault current.

  Making the plate supply overly robust (and low impedance) increases the
chances of a fault damaging things, if the supply caves in, hard damage is
minimized.
The SB-220 plate power supply was the perfect design for two 3-500s
throttled back to 1,000 input watts.  (then the limit)
--
  Ron  KA4INM - Youvan's corollary:
                Every action results in unwanted side effects.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


---
This email has been checked for viruses by AVG.
http://www.avg.com

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>