Amps
[Top] [All Lists]

Re: [Amps] Here's a new one for me that I'd like to share

To: <w2cqm@juno.com>, <amps@contesting.com>
Subject: Re: [Amps] Here's a new one for me that I'd like to share
From: "Jim W7RY" <jimw7ry@gmail.com>
Date: Tue, 5 Dec 2017 12:07:46 -0600
List-post: <mailto:amps@contesting.com>
A vacuum cleaner motor also speeds up when you plug the suction or the discharge.

That's the nature of a blower. Remove the load (moving air) and it speeds up.

73
Jim W7RY


-----Original Message----- From: w2cqm@juno.com
Sent: Tuesday, December 05, 2017 11:48 AM
To: amps@contesting.com
Cc: goodguyham@aol.com
Subject: [Amps] Here's a new one for me that I'd like to share

After some preliminary tests, I decided that a dual 8877 hombrew amplifier project would not be cooled adequately with a previously installed low RPM tandem blower. Checked the "junk box" for another candidate with higher speed and more volume and thanks to a long forgotten hamfest purchase, from yesteryear(s), I found a suitable replacement. The squirrel cage blower was larger and the manufacturer's label indicated TWO speeds. Imprinted on the motor were specifications including a 115VAC operating voltage and a schematic showing the three wire hookup sequence. Two color coded wires indicated line voltage input and the third wire (black) depicted the installation of an AC starting capacitor wired from that lead across to one of the color coded AC leads. NO VALUE WAS GIVEN TO THE CAPACITOR. I initially utilized a 1uFd cap for testing. I was disappointed since there were no other wires that could be used for speed selection. To test for suitabili ty, I nevertheless increased the opening for the larger blower mounting flange and installed it on the rear of the amp enclosure. It started to work; but nowhere near that potentially higher value of rotation stenciled on the motor body. I was a bit stymied at that point! Not certain what possessed me, but I decided to reach in and placed my hand over the blower output to restrict flow. Mysteriously, the fan substantially increased its speed. Removed the back pressure restriction caused by my hand and it slowed down. Not certain if I can explain the phenomenon , but I did experiment with much higher AC capacitors values and found the fan speed increasing but that resulted in the buildup of abnormal heat around the motor. That was unacceptable. I settled on the one and only low value 1 uFd capacitor I had since the amplifier cooling system was now operating well with adequate cooling volume. After replacing the tubes in the sockets and sealin g off the pressurized lower cabinet, the fan increased under the two tube cooling requirement restrictions and the blower motor heat build up is no longer an issue. Obviously, the automatic speed control has something to do with the value of the starting capacitor, the normal back pressure of cooling, and to some extent the resultant additional current draw. It's safe to assume that it's not a ghost nor is there an air flow control. within the fan body! Hopefully, someone can explain what's happening and share it with me and the other AMPS subscribers? Thanks, Ron W2CQM/3 Note! you can view some early digitals of this project with annotations on my QRZ site. Click on SHUTTERFLY at the bottom of the page.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>