Does anybody know the relationship between Q and SWR for a PI network?
For example let's say I design my amp PI output network for 7.0MHz. I
simulate the Tube Impedance with a 1K resistor. I put my MFJ259 on
the output of the PI and tweak the load and tune caps for a perfect
1:1 (50 Ohm) SWR. I now leave the caps where they were and adjust the
frequency to show the upper and low 2:1 SWR points and they are
7.2MHz and 6.8MHz. (2:1)=Fo/(Fu-Fl)=7.0/(7.2-6.8)=17.5. In practice
this is in fact about 1.5 times my design Q, but I would like to know
what theory says.
- Paul KW7Y
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|