From this document <http://www.ab4oj.com/dl/thp/hl2_5kfx/tuning.pdf>:
"If the POWER switch is turned on, while OPER/STBY switch is at
OPER(operate) position, the orange OPER lamp will
blink, and you will need to reset the OPER switch to enter into operation
mode. “PSE STBY OPERSW is displayed at this time."
Manual says something similar. So, if you are sure the OPER/STBY switch is
in the STBY position when you power up the amplifier, and you're sure that
nothing is plugged into the SEND jack by mistake (like an ALC cable), and
the amp. displays that message every time you power up, then perhaps the
OPER/STBY switch is defective or wired backwards.
73,
Bob, N6TV
On Tue, Dec 4, 2018 at 5:19 AM William Liporace <wc2l@wc2l.com> wrote:
> Hi Folks,
> I'm having an issue with the THP HL-2.5Kf and I have a couple of
> questions. I do have the 1.5C firmware. I have it hooked up to a K3. The
> amp is set to Yaesu band data. I know the amp used to work with a K3.
> The amp never seems to leave "PSE STBY OPERSW!" on the display after the
> amp is powered up.
>
> What causes the "PSE STBY OPERSW!" ?? Manual says power cycle the amp to
> reset it. I don't see any other answers... I have even pulled the plug
> and allowed it to sit...
>
> It does not seem to matter if the radio is hooked up amp. Does not
> matter if the the amp is in auto or manual mode. It also does not matter
> if it is in operate or standby. I wanted to check both fuses... One
> fuse I can't seem to open and one of the fuses is fine, but the amp
> powers up. My guess is that it is OK (bad thought?).
>
> Any thoughts? Really could use some help with this!!
>
> TNX Will WC2L
>
> --
> William Liporace WC2L
> http://www.wc2l.com or http://dxc.wc2l.com
> AR-Cluster Node telnet dxc.wc2l.com or 144.93 MHz
> wc2l@wc2l.com
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|