[Top] [All Lists]

Re: [Amps] Measuring IMD in a home workshop

Subject: Re: [Amps] Measuring IMD in a home workshop
From: Peter Bertini <>
Date: Sat, 25 May 2019 11:23:54 -0400
List-post: <>
Unfortunately, the K3 transmitter IMD specs are not good enough for
amplifier testing.  A two-tone generator is the easiest part of this

Not sure what the solution is, a pair of final amplifier decks from a Ten
Tec can be driven with two signal generators (HP 8640 will drive my Omni PA
decks to full power)  along with a combiner... but that will cost around
200 bucks for the assemblies from junker rigs.

Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>