[Top] [All Lists]

[Amps] 3CX3000A7 on 144 MHz

To: <>
Subject: [Amps] 3CX3000A7 on 144 MHz
From: "Jim Thomson" <>
Date: Fri, 7 Feb 2020 09:37:26 -0800
List-post: <>
Date: Fri, 7 Feb 2020 11:35:34 -0500
From: MU 4CX250B <>
To: Steve Thompson <>
Subject: Re: [Amps] 3CX3000A7 on 144 MHz

<     Seems to me this problem may  not be so troublesome. The dc
<resistance of the hot filament is 7.5V/51A=0.15 ohms. If the B- return
<is on one side of the filament, and if we assume the plate current is
<1ADC, then the maximum DC voltage drop across the filament would be
<only .15V
  <  Furthermore,  the filament emission is distributed across the
<entire length of the filament and not just at one end, so the average
<resistance is actually less than .15 ohm. What this means is that the
<variation in operating bias from one end of the filament to the other
<by using a switch mode power supply is at most a tiny fraction of a
<volt. For practical purposes, I think it could be neglected, which
<means a user would see no difference in performance, compared to
<using a center-tapped filament transformer.
<Jim w8zr

##  electrician buddy  across  town  re-wound a 24 volt  xfmr....and  used   
new 10  ga  wire.
5.6  volts....  loaded  with  30A.....for a hb  2 x 3-500Z  amp.....complete  
with  CT.

##  worked  good,  but loaded  V  at  the  cathodes  was  way  too  high.

##  he  removed  turns  from  ONE  end  only,  instead of  equal  amount  of 
turns  from  both  ends ! 
That  effectively put  the  CT  off  to  one  side a bit.   We  could all  hear 
 the  60hz  hum  across  town  on  75m  ssb.
Go  figure. 

Jim  VE7RF 
Amps mailing list

<Prev in Thread] Current Thread [Next in Thread>