Id use the same material as used in the Ameritron 1500W amp coils
Whatever that is, I keep forgetting! It might help to put some air flow on
them as the values are not ideal over a wide range of tube loads. The spec
was 2500-5000 Ohms
Carl
----- Original Message -----
From: "Mike Keller" <w1bnc52@gmail.com>
To: <amps@contesting.com>
Sent: Friday, August 07, 2020 1:30 PM
Subject: [Amps] B+W 850A parts?
I was fortunate to save a Classy home brew 2 / 4-400 KW amplifier in a 4ft
rack from a trip to the landfill and am trying to bring it back to life.
The coil support rods in the B+W 850a are missing and I am looking for
suggestions for replacements.
Mike Keller
W1BNC
Typos bye iPhone
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|