Is it possible to use distilled water in a hb dummy load ?
DL consist of 4 x 200 ohm globars, wired in parallel..in an 8 gallon
container.
I welded 4 x 3 inch OD thick wall Alum pipes together, 2 stacked above 2.
One resistor resides dead center in each alum pipe. Each resistor is a
new globar type SP, 12 inches long x 1 inch in diameter.
For the amount of brief testing I do, and sometimes with low duty cycles,
sometimes
high duty cycles, distilled water just might be easier to work with vs
xfmr oil.
To be used from 160-10m, no higher freqs.
What I am worried about is the dielectric constant of distilled water. That
appears
to be a lot higher than that of xfmr oil. It could add a bunch more stray
C to the mix,
esp with each resistor inside its own alum pipe..and pipes welded.
On paper, distilled water should be able to extract heat a lot better than
xfmr oil.
Jim VE7RF
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|