Amps
[Top] [All Lists]

Re: [Amps] Junk Connectors, Junk Coax

To: <donroden@hiwaay.net>, <jim@audiosystemsgroup.com>
Subject: Re: [Amps] Junk Connectors, Junk Coax
From: "Carl" <km1h@jeremy.qozzy.com>
Date: Thu, 15 Apr 2021 17:40:43 -0400
List-post: <mailto:amps@contesting.com>
I still run a HB 3CX1000A7 amp on 2M. Early tests smoked mil spec "UHF" and type N has been fine going on 30 years.

Carl


----- Original Message ----- From: <donroden@hiwaay.net>
To: <jim@audiosystemsgroup.com>
Cc: <amps@contesting.com>
Sent: Thursday, April 08, 2021 3:26 PM
Subject: Re: [Amps] Junk Connectors, Junk Coax


And back last cycle I ran 700 watts out of a Johnson 6N2 Thunderbolt on two with no heating issues.
Don W4DNR

Jim said
There is ZERO need for any thing better than a well-installed 83-1SP(no suffix) below 2M. The hand wringing about non-constant impedance is the result of a failure to understand transmission line
fundamentals.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps


---
This email has been checked for viruses by AVG.
https://www.avg.com

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>