Amps
[Top] [All Lists]

Re: [Amps] SB220 - 10 Metre input coil adjustment

To: Sam Ferris <ve5sf@sasktel.net>, <amps@contesting.com>
Subject: Re: [Amps] SB220 - 10 Metre input coil adjustment
From: gudguyham--- via Amps <amps@contesting.com>
Reply-to: "gudguyham@aol.com" <gudguyham@aol.com>
Date: Sat, 1 Jan 2022 20:44:48 +0000 (UTC)
List-post: <mailto:amps@contesting.com>
What kind of input swr are you seeing as you make these adjustments on the 
input coil?  10 meters is very touchy on these amps.  You also have to take 
readings at a set output power across the band to see if there is a marked 
increase somewhere.  This will tell you if you need to massage the 10 portion 
of the tank coils to bring the “ sweet spot” where you want it.  You should do 
that first off and then fine tune the input because it will make a difference!!


Sent from the all new AOL app for iOS


On Saturday, January 1, 2022, 3:04 PM, Sam Ferris <ve5sf@sasktel.net> wrote:

Wonder if anyone can tell me how sensitive/sharp the 10 metre input tuning
coil tuning is on a SB220.  I am repairing an SB220 for a fellow ham and
when I received the amp the central tuning slug for the 10 meter input coil
(part# 40-964) was in a bag of parts … seems the tuning slug had fallen out
sometime in the past.  It was noted that the 10 and 15 metre input coils
have the same part number so I measured the depth to the outer face of the
slug to the outer edge of the 15 metre coil to get an idea of just where the
10 metre coil should be set initially.  On initial tune up I was not able to
get more that about 450 Watts at 0.5A plate current and 110 mA grid current
on 10 Metres into a 1:1 SWR at 28.600 MHZ (Sweet spot for my antenna).  I
have tried one adjustment moving the coil slug in two turns which proved to
be the wrong way to go.  Have taken another look and decided to return to
the first setting plus about ½ turn out – then try again.  Can anyone advise
just how sharp the tuning on these input coils is?  Would it be best to
devote the time to making a temporary face plate that I can drill an added
access hole through to access the tuning coil from the outside?

 

The amp functions fine on other bands with reasonable output on a set of
EIMAC tubes.  Other repairs to this amp have included replacement rectifier
board, new parasitic suppressors – old ones showed significant signs of
heating, replaced broken bandswitch, soldered loose wires, general cleaning
and check of components.

 

Thanks

Sam

VE5SF

 

 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>