There was a similar amplifier for sale on QTH.com a while back. The
seller was a 6 meter EME enthusiast who appeared to be in the process of
downsizing. I suppose with one of those amps on each end of a link and
lots of aluminum in the air on both ends, you could ragchew on SSB with
your counterpart using 6 meter EME :-)
73, Mike W4EF...................
On 9/9/2022 5:29 AM, Pete Smith N4ZR wrote:
OK, I give up - what's the point of 10 KW CCS?
73, Pete N4ZR
Check out the new Reverse Beacon Network
web server at<https://reversebeacon.net>.
For spots, please use your favorite
"retail" DX cluster.
On 9/9/2022 1:39 AM, jim.thom jim.thom@telus.net wrote:
10 kw CCS on 6M..using the 3CX-6000A7.
Ok, here's the 3rd installment of this project.
Here, the socket and chimney are installed. Due to space constraints,
the
tube is in the corner. To get around piling on more stray C ..between
side
/ rear wall..and anode, I had him space the anode 2.5" away from
both. When
the space is say doubled, the C will drop to just 1/4. Same deal with
spacing between stator + rotor plates on an air variable.
Also note, instead of using machine screws to mount the .515" thick
chimney
to the chassis...threaded studs were used instead. Studs screwed into
the
teflon. Then chimney + studs dropped onto chassis. It's another way of
doing it. If mounting the chimney to the top lid, it's actually much
quicker using the studs.
https://www.youtube.com/watch?v=RBIT76-o6tM
<https://www.youtube.com/watch?v=RBIT76-o6tM&fbclid=IwAR10CtUWkUQ-LTRBvq6StAPbI2dhthPZTW5815ahAeuSY2t3I0ki02JF0vQ>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|