CQ-Contest
[Top] [All Lists]

[CQ-Contest] Ideal transceiver

Subject: [CQ-Contest] Ideal transceiver
From: ve4xt@mb.sympatico.ca (Kelly Taylor)
Date: Fri Jul 11 09:56:46 1997
Wish list (some of which is already available on some rigs):

1. multiple antenna ports
2. input, properly switched and with a built-in preamp with selectable levels 
of 
preamplification (or front-panel control for remote-mounted preamp), for a 
separate 
receiving antenna
3. RS-232 ready (no CI-V, IF232, IF10, etc)
4. built-in keyer with ports for both paddles and straight key (read: computer)
5. IF crystal filtering out the wazoo (a la 1000D)
6. audio DSP
7. remote control panel with main tuning, AF and RF gain, mic gain, key speed 
and DSP 
controls and sized to fit next to and match angle of the keyboard
8. a display that, in addition to VFO-a and VFO-b, indicates the last frequency 
on which 
a transmission was made
9. Quick memory (a la TS-850, 950, 570, etc)
10. Non-proprietary connectorization (ie. no 
hard-to-find-except-from-the-manufacturer 
DIN plugs, no requirements for outboard break-out boxes (like that goofy DIN 
connector on 
which Kenwood places ALC, PTT, Amp keying, etc.) and standardized mic pin-outs.)
11. Band-check button (like kenwood's TF set, this would be a momentary switch 
which 
allows the operator to quickly listen to the band of his choice, to check on 
openings, 
without altering auto antenna tuner settings (it could bypass the tuner) or 
sending band 
change info to the computer. Operator could use main tuning to scan band 
without changing 
frequency on previous band (important if this check is done while running). If 
needed, it 
could select a different antenna port. If the band was open, a quick release 
and press 
would change all functions to this band and so inform the computer. Otherwise, 
releasing 
button returns all functions to the previous band).
12. Insta-split. This key would allow the operator to instantly set split 
frequencies 
(ie. You hear a station on 7063 listening on 7234, press Insta-split, then key 
in 7234. 
On PTT, TX will be on 7234. At end of QSO, press insta-split again to return to 
non-split 
mode).

That's about all I can think of

73 all
kelly
ve4xt@mts.net


 -
 ---
CQ-Contest on WWW:        http://www.contesting.com/_cq-contest/
Administrative requests:  cq-contest-REQUEST@contesting.com

<Prev in Thread] Current Thread [Next in Thread>