I believe that's right, David, the RX port is not switched off/out when the
rig is transmitting.
To protect my radio, especially now that I have an amplifier, I installed a
relay to disconnect my K9AY loop from the FT-1000MP MARK-V Field during TX.
K9AY sells one:
http://www.aytechnologies.com/Products/RIP1data.htm
http://www.aytechnologies.com/
I could have made my own, but his was cheap enough that it wasn't worth my
time.
Best,
Brian Lambert
N1IK
-----Original Message-----
From: yccc-bounces@yccc.org [mailto:yccc-bounces@yccc.org] On Behalf Of
David Robbins K1TTT
Sent: Friday, January 07, 2005 2:15 PM
To: YCCC; reflector cq-contest
Subject: [YCCC] ft-1000mp beverage switching?
Trying to figure out how to do 2 radios on one band with mp's... it appears
that the beverage antenna input is not switched off when the ptt is keyed,
is this correct?? So when transmitting the beverage is still connected
through to the rx rf path? Or does the relay on the rf board that selects
the beverage input get switched back to the (now disconnected by the tr
relay) normal antenna line??
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
_______________________________________________
YCCC Reflector mailto:yccc@yccc.org
Yankee Clipper Contest Club http://www.yccc.org Reflector Info:
http://lists.contesting.com/mailman/listinfo/yccc
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|