CQ-Contest
[Top] [All Lists]

Re: [CQ-Contest] CT-17 Problem

To: cq-contest@contesting.com
Subject: Re: [CQ-Contest] CT-17 Problem
From: 7L4IOU <ncb02761@nifty.com>
Date: Sat, 10 Sep 2005 09:49:40 +0900
List-post: <mailto:cq-contest@contesting.com>
Hi

I think that CT-17 is working. 
It is difficult to measure the pulse by Volt meter. 
If it is not 0V and unsteady, it will be good. 

As for CI-V of ICOM, 
it is important to synchronize an CI-V Address.
and faster baud rate is good. 

My setup is as follows. 

--- IC-756PRO ---
CI-V Baud Rate:19200
CI-V Address:5Ch
CI-V Transceive:ON
CI-V with IC-731:OFF

--- N1MM Logger ---
Speed:19200
Pnarity:N
Data Bits:8
Stop Bits:2
DTR{pin 4}:Always Off
RTS{pin 7}:Always Off
Icom Code {hex}:5C
Radio/VFO:1


BTW
LOGER32 is the good tool of CI-V troubleshooting. 
You can monitor of the data exchange by 'Radio Debug Window'.

73 Hisami 7L4IOU

----- Original Message -----
From: <ku8e@bellsouth.net>
To: <cq-contest@contesting.com>
Cc: secc@contesting.com, mrrc@contesting.com
Date: Fri, 9 Sep 2005 9:41:29 -0400
Subject: [CQ-Contest] CT-17 Problem

>
>  I just purchased a used CT-17 CIV converter for my IC756PRO. I can't seem
> to get it working.
>  It didn't come with an instruction manual or any of the cables. I 
>happened to find a .pdf of the
>  manual online.
>
>    I have checked my cables and the CIV jack on the back of the IC756PRO 
>and they are OK. 
>  From what I understand the CIV (or remote) jack on the 756PRO should 
>measure between +4 and +5 volts.  When you turn on the CIV transcieve 
>option from the menu on the radio and turn the VFO the voltage should  drop
> somewhat.  I have double checked to make sure the baud rate is set 
>correctly on both the radio and programs. I have also checked my computer 
>and there are no conflicts on the serial  port - COM1.
>
>  I have tried it with CT (for Windows), N1MM and NA and I can't get it to 
>communicate with any of these
>  programs.
>
>  Does anyone know if the RS232 cable is wired special ? I used the one 
>that I have for my TS850S radio control box - just a DB25 - DB9 cable. I am
> using a 3.5mm mono  plug from the CT-17 to the CIV jack on the radio.  It 
>powers up just fine when 12 volts is applied.
>
>Anyone else ever have these problems ???
>
>
>Thanks, Jeff  KU8E
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest

<Prev in Thread] Current Thread [Next in Thread>