Or if using any of the fine AR-6 nodes out there for spots, issue a
SET DX EXTENSION LOTW command and receive a + sign attached in the
comment field of all spots where the user is LOTW
There are other extensions useful for both contesting and everyday
operating.
SET DX EXTENSION COUNTY is great for QSO parties.
STATE
SECTION
NAME
You can stack them as well. For example
SET DX EXTENSION NAME LOTW
Consult a user guide for the complete list.
Note that some node do not have the extensions enabled, but most do.
Dave K2XR
On 2/10/2021 11:08:13 AM, ko7ss--- via CQ-Contest wrote:
In the last few months I have been lured into the LOTW DXCC + Challenge. Of
course the
easiest way to get this done is operating contests. I sit with my N1MM bandmaps
filled
with skimmer spots, the LOTW Challenge chart open in a browser window, and
QRZ.com
open in another browser window. A bit OCD, I know.....
For any QRZ.com listing, it will say if the station uses LOTW or not. If they
don't use it
I don't bother to work them. It can be that simple. This is my casual contester
mode right
now and I suspect it is the same for lots of ops.
So, consider using LOTW. You may work more stations. And if you do use LOTW
please
upload your log right after the contest.
73, Bill KO7SS / 9A5SSS
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
_______________________________________________
CQ-Contest mailing list
CQ-Contest@contesting.com
http://lists.contesting.com/mailman/listinfo/cq-contest
|