> >
> > Hi,
> >
> > I'm trying to install a Network Interface Card in a 386 PC that has a K1EA
> > DVP board installed. According to the DVPTSR, the DVP board is configured
> > as IRQ=7 and base address=308H. When I configure the NIC to IRQ=10 and
> > address=300H, the card fails its loop back test and cable connect test.. If
> > I remove the DVP card from the computer, the NIC passes both tests.
> >
> > Looks like I need help from someone who understands bus addressing and
> > interrupts better than I do. Any help would be appreciated.
> >
timely question. i am experimenting with an ethernet tsr to replace
a comtsr for using ct over a network. just got it working with ethernet
card set for irq-10 and addr 320h. this one is software configurable so
changing it is pretty easy. i do have the dvp set for irq-7 and 308h,
and
just tried it with comtsr1 for packet and comtsr2 for the radio and lpt1
for
cw keying without any conflicts. now i have to get some more cards and
try
with more than 2 computers on the network.
--
David Robbins K1TTT (ex KY1H)
k1ttt@berkshire.net or robbins@berkshire.net
http://www.berkshire.net/~robbins/k1ttt.html
--
Submissions: ct-user@ve7tcp.ampr.org
Administrative requests: ct-user-REQUEST@ve7tcp.ampr.org
WWW: http://www.ve7tcp.ampr.org/Software/ct
Questions: owner-ct-user@ve7tcp.ampr.org
|