ansi.sys gets loaded in your config.sys when you start the pc. i use
the line
devicehigh=\dos\ansi.sys
or
device=\dos\ansi.sys
in the config.sys to load it.
Richard L. King wrote:
>
> I have seen this queston asked before but I have never seen a public answer.
>
> When I start CT using VGA mode, I have a problem when I exit the program.
> The PC screen stays in VGA mode and only uses half the screen. I also get a
> message that says something to the effect, "ANSI.SYS needs to be
> installed". I have to re-boot the PC to get back to normal monitor mode.
>
> I have the ANSI.SYS program, so the presence of that file isn't enough to
> fix this. I must need to do something more?
>
> I am running a 386-SX and CT 9.39.
>
> Thanks.
>
> 73, Richard
>
> k5na@texas.net
>
> --
> Submissions: ct-user@contesting.com
> Administrative requests: ct-user-REQUEST@contesting.com
> WWW: http://www.contesting.com/ct/
> Questions: owner-ct-user@contesting.com
--
David Robbins K1TTT (ex KY1H)
k1ttt@berkshire.net or robbins@berkshire.net
http://www.berkshire.net/~robbins/k1ttt.html
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|