At 09:08 AM 12/09/1999 -0600, Hans - K0HB wrote:
>I don't think it oughta make a difference, but rather than load the
>baud rate setting into comtsr, I load it at the CT setup window.
>I just start the comtsr with interupt and address settings, then
>setup the speed (9600) in CT.
The COMTSR has no effect on the baud rate setting. It's what you tell CT
in the COM port setup that's important.
--
Jim Reisert AD1C <jjreisert@alum.mit.edu>
http://people.ne.mediaone.net/ad1c/ <---- note new home
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.k1ea.com/
Questions: owner-ct-user@contesting.com
|