Dave,
Did you go through the COMMUNICATIONS SETUP screen where you tell CT which port
is Radio1, Radio2,
baud rate, etc.?
If you have CT already running, type SETUP in the call entry space and hit
enter.
73, Ted W4NZ
-----Original Message-----
From: ct-user-bounces@contesting.com
[mailto:ct-user-bounces@contesting.com]On Behalf Of Dave VO1AU
Sent: Friday, March 24, 2006 11:38 AM
To: ct-user@contesting.com
Subject: [ct-user] CTWin 10.03.002 serial port problem?
I've just downloaded the latest version of CTWin and I'm having trouble
getting the program to recognise that my Kenwood TS-950 and TS-850 are
connected through COM1 and COM2, respectively. The program acts as if there
are no rigs connected.
I have set up the ports with the correct speeds (4800 baud each). My other
logging software communicates correctly with the rigs, but not this version
of CTWin.
Is there a step I'm missing?
Dave VO1AU
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|