RE: [Karlnet] hello there

[Roger Boggs <rogerboggs@att.net>]

Miscellaneous SNMP errors can occur if you're using an older version of the
configurator with the newer firmware.  Check this first.

Also beware - there are two ways to load new firmware.

First is to do an open remote config then upload firmware that you select
in the dialogue box.  MACs and keys are usually pre-entered for you this way.

Second is to do a "reload from nothing" where you use reset switches
to put it in firmware upload mode.  First thing you do is open config file and
select the binfile.  Then you do an upload firmware and enter all the mac 
and keys.


At 04:19 PM 4/24/02, you wrote:
> Nope, I even got to the point where I downoladed the config changed snmp 
> router name (no real change to the configuration) and tried uploading 
> that, it's still the same.
>
> I don't change my IP neither I get confirmation that my settings have been 
> saved - just the same SNMPsomtething timeout error.
>
> Regards,
> Leszek
>
>
> At 16:11 2002-04-24 -0400, you wrote:
>
>
>
> > > 6. I try uploading the configuration - it seems to read data from
> > > computer
> > > for 2-3 seconds then reboots, computer keeps on sending data and
> > > after some
> > > 15 seconds I get error message about invalid snmpkey and timeout
> >
> > One other question...   Are you changing the IP address during your
> > modifications here or  on the SCAN menu where it says CHANGE IP ?
> >
> > Bill
> >
> > _______________________________________________
> > Karlnet mailing list
> > Karlnet@WISPNotes.com
> > http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet

Roger Boggs