As a cisco engineer, I found the routing setup on the lucent ap's different
at first, but then after playing with it I realized you make "interface's"
with each direct route.
I would use either routing or bridging not both (unless you are using apple
talk or IPX)
Dan Metcalf
Wireless Broadband Systems
dan.metcalf@wbsysnet.com
781-658-2075
www.wirelessbroadbandsystems.com
-----Original Message-----
From: Bill Fisher [mailto:fisher@akorn.net]
Sent: Friday, April 26, 2002 12:49 PM
To: karlnet@WISPNotes.com
Subject: [Karlnet] Karlnet Routing
Charles has been trying to get this routing stuff through my thick head, and
so far all I can do is make bridging work. Maybe someone else can jump in
with some advice?
Here is my set up:
http://www.wispnotes.com/pdf/AkornWirelessRouting.pdf - Ignore router setup
box bottom right.
My internal network is almost all 216.1.128.0/24.
I have 216.1.129.128/25 setup in the border router to route to 216.1.128.91,
the Teletronics box.
Can someone give me a scenario where the 2 AP-1000's at the remote tower
will route and work on my internal network? I have gotten as far as them
working outside the border router, but not inside.
Does the remote AP-1000 that forms the link need to have bridging and
routing turned on? That is what I have been using.
Thanks!
Bill
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|