Roger,
That is exactly where I got the instructions. They even list the files to
erase but I didn't go into the reg. nor did it state to. I guess I will try
that.
---------- Original Message ----------------------------------
From: Roger Boggs <rogerboggs@att.net>
Reply-To: karlnet@WISPNotes.com
Date: Mon, 13 May 2002 15:39:56 -0400
>You must thoroughly and completely uninstall the Orinoco 802.11b drivers
>and all it's remnants
>from the machine before you install the TC Client software. It usually
>involves editing several
>lines in the registry to totally remove it.
>
>This procedure is, or at least used to be, documented in the readme.txt
>file that came with the
>TC Client download.
>
>I don't know for sure, but I doubt that the procedure has been streamlined
>in recent months.
>
>Anybody got a link for the TC "pre-Install" procedures on a machine that's
>already had
>Orinoco drivers installed on it?
>
>
>At 02:45 PM 5/13/02, you wrote:
>>Lister,
>> Have any of you seen this problem? I have an AP1000 with the TurboCell
>> ISP Base upgrade. I got it loaded with some help from a few of you.
>> Thanks. It is connected ethernet side via crossover cable to a desktop
>> and communication is no problem thru the configurator.
>> I installed the TurboCell NDIS on my laptop which already had the
>> Win98 drivers for the orincoc card. During the install the wizard
>> repeatedly and alternately asked for pubprot and secur32 files. I located
>> these files and pointed the wizard to them. After all was said and done a
>> message stated I already had a device installed and couldn't run both
>> drivers. So I switched to plan B and erased the drivers listed and went
>> with a fresh install. I basically went thru the same thing as above but
>> when it was done, it had the TC setup for client manager and wanted the
>> key, NWID, rate, ect. With all info typed in, I restarted the system and
>> started client manager. It stated no driver present. I switched the
>> profile to AP and the driver appeared. Switched it back to TC and the
>> driver is still there but the manager wont search off of channel 10. I go
>> to the desktop and do a link test via configurator and it shows excellent
>> signal and no packet loss. The laptop still shows nothing. La!
>>ptop cant ping AP either. Any thoughts or ideas. This is the latest
>>version by the way.
>>Thanks,
>>
>>
>>--
>>Eric L. Johnson
>
>Roger Boggs
>
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
>
--
Eric L. Johnson
WarpSpeed Internet
1-361-563-3742
--
|