Bill,
I haven't had to reboot a cpe because of this, just wait a minute and
try again.
Granted - karlnet should offer some type of pure signal/noise of each
channel in the software
Dan Metcalf
Wireless Broadband Systems
http://www.wbsysnet.com/
877-685-0578
dan.metcalf@wbsysnet.com
> -----Original Message-----
> From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]
On
> Behalf Of Bill Fisher
> Sent: Tuesday, November 19, 2002 12:20 AM
> To: karlnet@WISPNotes.com
> Subject: [Karlnet] Bug
>
>
> In all versions of the Configurator that I have here, the following
> occurs:
>
> Wireless Link Test ---> Explore ----> Link Test
>
> Now, if you happen to lose the link (aligning antennas or whatever)
you
> have
> to reboot the remote because config.exe reports that there is already
> another link test going on.
>
> A much bigger deal 100 feet up on a tower on a 3750' mountain with a
> laptop
> in 30MPH winds at 37 degrees F.
>
> Honestly, Karlnet is not very friendly at all when it comes to making
a
> link
> happen. I think NetStumbler is much more useful if you put the radios
in
> 802.11 mode. And, Teletronics has a pretty good site survey tool.
>
> Bill
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
> ---
> [This E-mail scanned for viruses by Declude Virus]
---
[This E-mail scanned for viruses by Declude Virus]
|