can't Route & run NAT at the same time
-Charles
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Bill Fisher
Sent: Sunday, December 01, 2002 8:48 PM
To: karlnet@WISPNotes.com
Subject: [Karlnet] Routing with DHCP & NAT
Can someone please tell me how to configure a KN AP on an AP-1000 to do
routing and allow users to connect? I'm having a devil of a time. I have
the following routing set up:
10.10.11.2 255.255.255.252 Direct 3
209.49.136.193 255.255.255.192 Direct 1
10.10.13.1 255.255.255.0 Direct 2
Default route is 10.10.11.1.
DHCP Setup:
Starting address: 10.10.13.2
Ending Address: 10.10.13.254
Default Router: 10.10.13.1
Default Router Subnet: 255.255.255.0
Do I need to setup outgoing NAT now? And if so, how?
IP traffic is passing through the router fine, but when I connect to this AP
(interface two above), I can't pass any traffic through it.
Thanks
bill
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|