For Windows, I think the name that is reported on link tests is the name of the
computer.
For Linux, the reported name can be specified in this line of the config.opts
file:
module "wavelan2_cs" opts "port_type=3 license=<license key> protocol=1
channelautoselect=1 pp=<passphrase> station_name='My Station Name'"
*********** REPLY SEPARATOR ***********
On 2003-May-17 at 8:47 PM Robert Farrar wrote:
>Hello List users,
>
>Just a question re Turbocell NDIS, IS there a way to name each NDIS clients
>machine so that when I open up the ISP base station with configurator and
>check the turbocell station entries list it does not just say " HERMES 1 "
>or when remote link test it reports the unit as " HERMES 1 & mac address "
>.
>
>It would make it easier to see network names when alot of NDIS clients are
>accessing the access point.
>
>Is there a way to do this or not ?
>
>Regards,
>
>Robert Farrar
>Australia
>
>_______________________________________________
>Karlnet mailing list
>Karlnet@WISPNotes.com
>http://lists.wispnotes.com/mailman/listinfo/karlnet
|