Bad power injector? Disconnect the injector from the AP and measure DC voltage
across center conductor and shield - CAREFULLY, of course. Shouldn't be any
power supply voltage showing there. It should only show on the amp side of the
injector.
At 01:25 PM 9/2/03 -0500, you wrote:
I have an antenna problem that I was wondering if anybody else has had or
heard of? I have an AP-1000 hooked up to a hyperlink amp running up a tower
about 150 feet to a omni antenna. When we hook up the amp the AP-1000 over
heats. I have checked all the connections to make sure that we are not
backwards and I can't figure out what is going on, this amp is not rocket
science. Any ideals
wes
Roger Boggs
|