Karlnet
[Top] [All Lists]

RE: [Karlnet] Getting Back In

To: "'Karlnet Mailing List'" <karlnet@wispnotes.com>
Subject: RE: [Karlnet] Getting Back In
From: "Jayson Baker" <jbaker@peakinet.net>
Reply-to: Karlnet Mailing List <karlnet@WISPNotes.com>
Date: Sun, 16 Nov 2003 14:21:09 -0700
List-post: <mailto:karlnet@WISPNotes.com>
I said, "Connect to it on either wireless end with an RG in bridging mode -
yes, you may need to use a crossover cable."  As in, there's an RG connected
to this KN-200 - go to it, plug into it, do what I said.

No, you won't be able to get to it through the AP-1000 unless it, and the
adjacent RG, are both in bridging mode. How can you get to it via routed if
there's nothing routed?

Regards,
Jayson A. Baker
Peak Internet Solutions

-----Original Message-----
From: karlnet-bounces@WISPNotes.com [mailto:karlnet-bounces@WISPNotes.com]
On Behalf Of jna
Sent: Sunday, November 16, 2003 2:16 PM
To: Karlnet Mailing List
Subject: Re: [Karlnet] Getting Back In




> Your descriptions are very difficult to follow.
>
> I think I understand it as your KN-200 doesn't have any IP's assigned to
the
> wireless interfaces... this doesn't matter.  Connect to it on either
> wireless end with an RG in bridging mode - yes, you may need to use a
> crossover cable.  If you can't figure out how to get a physical Ethernet
> link you shouldn't be working with ANY of this equipment.

No, Its not that I do not know HOW to get to the Ethernet port of the KN-200
it is I do not have PHYSICAL access to any of it at this time. Other wise I
would have just plugged into it via a cross over along time ago and been
done with it. The problem is I again do not have physical access to do this
at this time and only have the remote links attached to it. unfortunately
the only unit I can not get to 24/7 yet is the one that is messed up and
that is the kn-200.

I figured since the rg connected to it (kn-200) was connected to the same
switch the ap1000 is connected to that I could see if via my home wireless
link. I will check using a cross over to that rg see if I can see the kn.

> Link up to the KN-200 with the RG and hit scan - you'll see that AP in
your
> list.  If it has an IP of 10.something you'll need to change the IP on
your
> laptop to 10.something-in-the-same-subnet.  If it's 12.something, same
goes.
> --
>
> I understand what you're doing with the routing now.  Setup the RG on the
> datacenter as a bridge.  Make the KN-200 a router

Got get into it first :)

Thanks,
John

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet

<Prev in Thread] Current Thread [Next in Thread>