Hi Power cards with Prism 2.5 are supported just in Trubocell mode. Start
with an Orinoco, configure the interface as Turbocell (not AP) save the
configuration and then switch to your Hi Power card... it will work then :)
----- Original Message -----
From: "Michael McDermott" <michael@veritech.com.au>
To: <karlnet@WISPNotes.com>
Sent: Tuesday, November 18, 2003 10:17 PM
Subject: [Karlnet] RG-1100 Problems with High Powered Cards
>
> I'm currently having problems with 100/200mw Senao cards in RG-1100
> devices. The RG-1100 device will not totally boot up with the 200mw card
> (freezes half way thru the boot up process), but will boot up and work
with
> low power cards (Orinoco cards). Any ideas?
>
> TC firmware is SR-4200 using knscotcn-v4.43k.bin
>
>
> Michael R McDermott BEng (Comp. Eng.), MACS, IEEE
> Pre-Sales Technical Consultant
> Veritech Australia Pty Ltd
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
>
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|